Wire through the pipe, why more and more masters use this instead of wire rope?

Wire threading is a method of installing wires, mainly by punching holes in buildings and routing wires through pipes. This method is not only simple and efficient, but also can effectively protect the wires from damage and short circuit.

Wire through the pipe has the characteristics of strong structure and easy maintenance, which makes the wire more tidy and beautiful when passing through the wall, floor or ceiling. At the same time, wire penetration can also reduce the flammability and fire risk of wires, greatly improving safety.

In the daily home decoration, the wire pipe is also more and more valued and applied by people. The following is an introduction to the method of threading through the threading device, which is not only faster, but also improves the aesthetics of the wire. The wires are neatly hidden in the pipeline, avoiding the situation that the wires are scattered on the wall in disorder, and making the electrical installation more beautiful and elegant.

In the traditional method of threading wires, a small wire is usually used in order to insert wires into the wire tube. Insert a small wire into one end of the wire tube and make sure it runs smoothly the entire length of the tube. Next, tie one end of the wire to a small wire, which can be fixed with a knot or tape, to ensure that the wire does not fall off.

Slowly push the small wire along with the wire into the wire tube until the wire is completely inside the tube. Finally, check that the wire is securely placed inside the tube to ensure safe use.

This method is very simple but very practical. But it increases the time and cost of construction. Secondly, small steel wires are easy to break or damage, resulting in weak wire installation, and may even lead to safety hazards such as short circuit or fire.

However, with current technology, there is a simple and efficient way to thread-using a threading tool. This tool is compact and makes it easy to route wires through narrow ducts or concealed spaces. All you have to do is attach the wire to the threading tool and nudge to complete the threading process.

The threaders are also very simple to use. First, make sure you have the threaders, wires, and other necessary materials ready. Then insert one end of the wire into the opening of the threader, making sure to hold it tight and steady. Find holes or pipes to be threaded and ensure the site is clean and well prepared. Push the threader slowly along the hole or pipe until it reaches the desired position. Once the threader reaches the target position, steadily pull out the threader while bringing out the wire. That way, you can easily thread!

Threading device can greatly improve work efficiency. Second, the threader is very simple to use. Just need to insert the thread end into the gap of the threader, and gently press, you can complete the thread penetration, do not need too much skill or effort. In addition, the threader also has good compatibility. Threaders adapt and work best with thick or thin threads. In addition, because it is compact and portable, it can be carried at any time and is convenient to use in different occasions. In general, the advantages of the threader are to improve work efficiency, simplify threading steps, strong compatibility, portability and flexibility.